USGlobalSat GPS Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Pages: [1]   Go Down

Author Topic: Device would not turn on  (Read 939 times)

GS_TECH01

  • Administrator
  • Hero Member
  • *****
  • Karma: 5
  • Offline Offline
  • Posts: 1755
Device would not turn on
« on: May 03, 2011, 12:11:20 pm »

If the BT-359 does not power on at all, please try to troubleshoot the unit by following the steps below:
  • Make sure the device is fully charged.
  • Power on the device around one second. Observe if any lights are blinking.
  • Plug-in the cable and connect the receiver to the computer. Repeat Step 2.
  • Turn off the unit and remove the battery. Insert it back. Again, repeat Step 2.
  • Press the Power button around 5 seconds to reset the device. Check the LED status.
  • If the issue still persists, please contact seller for replacement. Possibly, the device is defective.
Logged
Pages: [1]   Go Up
 

Page created in 0.176 seconds with 19 queries.